Answered
toolpath run over the material surface
I were creating 2D toolpath with complex and very small design around 2-3 mm. (height of the text). I using 3d machine relief it is because it saves time in making toolpath especially on small gap (normally it using smart engrave) but simulation shows machine run over the material. Please kindly let me know, i did something wrong? when machining, it was exactly the same as showing in simulation.
Comments
Hi Montien Eiamwonghiran,
Your post has been escalated to a Support Request by Carveco Support, and the associated ticket is #15421. Please reply to the Support Request with the requested information.
Thanks for your time and cooperation.
Please sign in to leave a comment.