Avatar

Mike Redd

  • Total activity 9
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 3
Follow

Activity overview

Latest activity by Mike Redd
  • Mike Redd commented,
    1. Community
    2. Engraving Talk
    3. V-bit issues

    I will double check that tomorrow!! thank you

  • Mike Redd created a post,
    Answered

    V-bit issues

    1. Community
    2. Engraving Talk

    This is my first time using a v-bit and I'm having issues. My settings: Start Depth is 0 and my Max Depth is .125  60 degree v-bit  I have tried using paper method and my probe for zero. When I wat...

    • 2 followers
    • 2 comments
    • 0 votes
  • Mike Redd commented,
    1. Community
    2. General Discussion
    3. logo

    it is 8x8' I plan on working on it tomorrow

  • Mike Redd commented,
    1. Community
    2. General Discussion
    3. logo

    Thank you all. I have successfully got the image into Carveco Maker. I am using bitmap to vector, but this is the first time I am trying to create a toolpath for an image like this. The area around...

  • Mike Redd created a post,
    Answered

    logo

    1. Community
    2. General Discussion

    Hey everyone i am trying to add a logo to carveco. I am able to get it there and view it but its very blurry and pulling my hair trying to figure out why. Here is the logo. Can anybody explain this...

    • 3 followers
    • 7 comments
    • 0 votes
  • Mike Redd commented,
    1. Community
    2. Maker & Maker+ Support
    3. The layout has changed and can I switch it back?

    Lonnie I have the same issue my layout on the right side of the screen does not show  project. Where is this question mark you found? Thanks mike