Avatar

Bill Bertham

  • Total activity 9
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 3
  • Subscriptions 1
Follow

Activity overview

Latest activity by Bill Bertham
  • Bill Bertham commented,
    1. Community
    2. Feature Discussion
    3. Brady's Wish List

    I have no idea about the more expensive versions of Carveco or what it can do, but like Mike I am old and I do this as a paying hobby, having bought Both Aspire and VCarve Pro I do not have great ...

  • Bill Bertham commented,
    1. Community
    2. Feature Discussion
    3. Brady's Wish List

    I can see where Carveco could be, it's just infuriating that no one is taken it there. There is a lot I like about this program but also lot I don't. There is a lot of unnecessary and confusing st...

  • Bill Bertham commented,
    1. Community
    2. Feature Discussion
    3. Brady's Wish List

    I have just downloaded the latest version of maker. And I use V Carve plus 11 and Aspire 9.5

  • Bill Bertham commented,
    1. Community
    2. Feature Discussion
    3. Brady's Wish List

    I am new to Carveco, but I am already confirming what you have said. I use Vectric all of the time but I was attracted to Carveco for the reasons you mention that it has over Vectric, but on the ...

  • Bill Bertham commented,
    1. Community
    2. Feature Discussion
    3. Brady's Wish List

    Having read all your needs, I think you are better using Vectric as it has most of what you are asking for. But must admit it would be great if they were incorporated into Carveco.