Tayfun Türkmen
Activity overview
Latest activity by Tayfun Türkmen-
Tayfun Türkmen commented, You can be sure that this is only simulation view. When you cut the part, you will get what your vector has with the defined toolpath tolerance. Even higher resulations, there is always similar vie...
-
Tayfun Türkmen commented, Carveco automaticly converts INC's to MM. Here is a sample.
-
Tayfun Türkmen commented, I think you are looking for components libraries. You can find all libraries here. https://support.carveco.com/hc/en-gb/articles/360026107672-Where-can-I-find-your-Relief-Clipart-Vector-and-Compon...
-
Tayfun Türkmen commented, There is another advantage to use END of the post processor. You can define a fixed position like; END = "N[N] G00 Z50"END = "N[N] G00 X0 Y1500" It can move the head to the back side of the machine.
-
Tayfun Türkmen commented, By choosing tick you mentioned at the Save Toolpaths, you just remove the green marked line from the NC code. Because of it is also inside the post post processor, you will still see the home posi...
-
Tayfun Türkmen commented, This is not only related with the option you choose in here. Also your post processor has some control as END = "N[N] G00[ZH]"END = "N[N] G00[XH][YH]" at the end of it. You see these value at your ...
-
Tayfun Türkmen commented, If you are machining only 2D toolpaths, resolution is only effect on simulation. It doesnt effect production quality of toolpath. Here is the view of different tolerance values. Your toolpath looks...
-
Tayfun Türkmen commented, It looks like you have a machining tolerance problem in here. You dont need to spline vector to correct this issue. Just adjust the machining tolerance at your toolpath. We use mm system in here s...
-
Tayfun Türkmen commented, Hi Everyone, I'm Tayfun Turkmen from Turkey. I've worked on the sales, support and training of ArtCAM in Turkey since 2002. I'm very happy to see that ArtCAM will continue as Carveco. Regards