Leighton Ashcroft
Comments
-
Adrian Walker wrote: "Thank you for your reply. I am familiar with the Area Clearance toolpath, but I didn't realise it could pick out the details like this. Do I still need to run a Profile after ...
-
Adrian Walker wrote: "Is there a Rest Machining function on 2D Profiling? For example, if a bigger tool can't fully get into the detail when 2D Profiling, can the remaining areas/material be auto-s...
-
Adrian Walker wrote: "It looks like it was due to the grouped curves. If I ungroup each single letter, then it seems to work fine" Glad you got it sorted, Adrian. When you create the text, rather t...
-
Hi Adrian, Adrian Walker wrote: "Sometimes when I select a node and press "D" it won't delete. Sometimes I select nodes and press "D" and they do delete instantly and sometimes when I select a nod...
-
Adrian Walker wrote: "See the image below; there is one green node. Could this be marking the start / end of the profile?" The green node is the start point of the vector, Adrian. If you were to ma...
-
That looks lovely Mike, good stuff!
-
Hi Bill, You could use the Panel Toolpaths tool, but the problem you will face is that you cannot optimize afterwards, and will use more material than you would like. Shown below is a quick example...
-
Fair enough Frank, its just I've never seen a CNC that needs feed rates on every single line otherwise it slows down. We don't have any posts in Carveco that do this and I cant recall ever having ...
-
No need to apologise Frank. The reason those feed rate moves are not on every line is because it should always stay constant until the next time that a F command is mentioned in the code, this cou...
-
Hi Frank, could you elaborate a bit please? What do you exactly mean that the cutting speed varies? I'm reading this as it starts cutting with a feed rate of say 100mm/min and then changes to 500...