Michael Sherve
Comments
-
Just a quick question, I haven't upgraded in a while, but would love to and would if this enhancement has been added, I have looked at the notes but I haven't seen these added but I could have just...
-
You have an outside vector then create an inside vector then rerun the toolpath to run between the vectors. mike
-
https://forums.autodesk.com/t5/artcam-forum/double-rail-sweep-problem-with-rectangles/td-p/7400769/page/2 Mark go to the link above read it then try out the tutorial in the last post. I added this ...
-
I looked at the 265.0 and the 200 and thought metric (smiley face here) you can always import it and change the dimensions. If you would look at the process that I used you could see that it was ra...
-
Mark here's the full file not just the vectors. mike https://we.tl/t-pe7hCcEh0N You have 7 days to get this.
-
mark, Here's a link for the vector files with definitions and instructions on vector layers, hope this helps. https://we.tl/t-SNnMK2fmpd
-
Mark, Forgot to add, the discoloration could be because the shank of your end mill is larger than the diameter of the flutes, you might want to ask your supplier, it just might be caused by the ...
-
Mark is this what you are after?mike
-
Mark, If you want I could get everything ready for you to do a 2 rail sweep, all I would nee would be the size of the foam the depth of the concave the x and y dimensions and if you would like t...
-
Mark, OK, the 2 rail sweep tool can be used for precise, or sloppy it all depends on what you want. With depth sometimes you can hit the apply too may times by accident then you can get to say some...