Michael Sherve
Comments
-
Jim, Have you tried to contact support directly, they are great people if there is a problem with the software they should know so they can fix it, if it's a problem with your computer they can...
-
Chuck, It all depends on what you want to do. If you want to do round you do it just like you would do on a lathe, same if it's off center. mike
-
Collin, It just might be the font. Which one did you choose? Choose a different one, there are fonts that go from right to left and some that tend to go up and down and some that are just squirr...
-
Zachariah, That is a beautiful font, it does need some fixing, but I don't think I'd be using it much. When I put the "H" on to a 9.5 by 15 inch modeling area, there was quite a bit to be concerne...
-
Zachariah, Do you mind giving me the fonts and possibly the text, I would love to give a try. Right now my router is rather busy, but I would really like to give a charge at it. I have a pr...
-
Zachariah, Have you tried to sand the bottom of the male part? There are reasons for a "V-bit" it gives you the right clearance, just encase there are variations in your "Z" or the wood, try usi...
-
Mike, I just noticed you don't have the full version, tell you what send me a file and I'll do the down slope, I'll send it back after I'm done for you to verify, I'll even enclose a small conca...
-
Michael, I had some 3 degree undercuts here resonantly, I had to go to my saw sharpener and get a bit ground to that (did a beautiful job). In all programs that use a 3 axis machine are going to...
-
Did you check your trash, I found some of my sons emails in my trash. I've used this stuff since 2008 (checked yesterday) when ever I contacted support they were always helpful, even when I screwe...
-
Ken, There are some instructions in the reference helps. mike