Gary Kicken

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

Ok...excellent...thanks very much!

• View comment
• Created 11 February 2020 01:14
• 0 votes

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

Thanks very much for the pointers... I'll try the exercise you recommended!

• View comment
• Created 11 February 2020 00:31
• 0 votes

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

I finally found the description of the "multiply" combine mode in 2015 R2..."Multiply to multiply the height of the relief layer's points by the coincident points on the visible layers below in the...

• View comment
• Created 10 February 2020 23:43
• 0 votes

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

I am going to have to get a handle on the "multiply" combine tool... I'm not sure what exactly that does, and have not found a description of it's use in the contents search...

• View comment
• Created 10 February 2020 22:44
• 0 votes

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

Yeah, I had to go take a nap after trying to follow that process!

• View comment
• Created 10 February 2020 22:40
• 0 votes

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

https://m.youtube.com/watch?v=x70yCmR9hvo 

• View comment
• Created 10 February 2020 15:53
• 0 votes

1. Community
2. General Discussion
3. Zero Rest

Thanks Michael and Barry...much appreciated!

• View comment
• Created 08 February 2020 13:58
• 0 votes

1. Community
2. General Discussion
3. Zero Rest

Thanks much...still finding my way around...

• View comment
• Created 07 February 2020 20:05
• 0 votes

1. Community
2. General Discussion
3. Zero Rest

Are these icons the "Zero inside Vector" and "Zero outside Vector"?

• View comment
• Created 07 February 2020 15:10
• 0 votes

1. Community
2. General Discussion
3. Zero Rest

I would like to know the answer to this question....

• View comment
• Created 07 February 2020 03:10
• 0 votes