Timothy Wells

1. Community
2. Maker & Maker+ Support
3. Error Saving Toolpath: Selection Only Contained Open Vectors

Hi Mike, Thank you for your reply.  I am very new myself and did not know about using v-groove for doing open vectors!  I think that may solve at least most of my problems...live n' learn! As to th...

• View comment
• 0 votes

1. Community
2. Maker & Maker+ Support
3. Error Saving Toolpath: Selection Only Contained Open Vectors

I understand that it was bumped up to support, but once resolved for the OP, why not post a brief on the solution here for everyone else?  I am sure that the OP is not the only maker which has that...

• View comment
• 0 votes