Answered
"Create Boundary From Relief" not accurate
Dear all, I just realised that when I create a boundary from a relief, the boundary actually lies about a 0.08mm inside the relief. I had to offset the created vector to get good results with my boundary.
Has anyone else noticed this? Can this be fixed?
Comments
Hi Rossella,
You have posted a question to the Community Feedback area, which is intended for making suggestions about our Help Centre and its Community rather than for seeking guidance on how to resolve a software usability issue.
Your post has been escalated to a support request by Carveco Support; your ticket number is 4015. Please check the inbox associated with your registered email address.
Thanks in advance for your time and consideration.
Please sign in to leave a comment.