Cassie Marie
I work as a Software Engineer based in Thailand. With over four years of experience in software development and an additional six years in web development, I thrive on crafting solutions that merge creativity with technical precision.
Comments
-
Hey there, I also had this similar issue but I resolved it by these steps: Check your mouse settings and Carveco navigation settings. Update your graphics card and mouse drivers. If that doesn't w...
-
This error usually indicates a mismatch between the expected and actual machine positioning. Double-check your G-code for any unusual commands, ensure all axes are calibrated correctly on the offli...
-
Thank you very much Michael Sherve
-
Hey there, When you have to keep the ball nose cutter from cutting into the tabs on your 3D carving, adjust your CAM settings. Use a smaller tool for the tabs, or set a boundary around them in the ...