Answered
How to remove jaggedness
Hey all,
Trying to simulate toolpaths, but it seems that I am getting a very jagged simulation. Tried smoothing relief, didn't help. I am also using 1mm ballnose, so that should be fine enough, at least it was good for previous models. Any ideas? Resolution is also the highest possible. 
Comments
In looking at your toolpath look at the settings you have set and use, what is your tolerances in your toolpath, have you tried to set a different angle of cut, like 45 or 90 degrees?
idea shooting in the dark
mike
I just went through a similar issue. I created a new model at max resolution but I created a model about 1/2 the size as my set dimension, I then reduced the model size again by 40%. Completely my fault.
I think what I've found is that 1mm ballnose is not small enough for this kind of detailing. I added a 0.25 tapered ballnose bit to the carveco tools (well modified the existing jewelry bit really) and it improved the detailing.
Please sign in to leave a comment.