1. Carveco Help Centre
  2. Community
  3. General Discussion

Just updated to v1.52 and appears to be an issue

Avatar
Tim Ouellette
Follow

Hi all, I just updated to V1.52 and after bringing up Carveco and creating a new model I find that when I attempt to zoom in or out the model (2d or 3d) zooms and then moves in the opposite direction of the cursor. Has anyone experienced this?

0

Comments

1 comment
Sort by Date Votes
  • Avatar
    Cassie Marie

    Hey there,

    I also had this similar issue but I resolved it by these steps:

    1. Check your mouse settings and Carveco navigation settings.
    2. Update your graphics card and mouse drivers.
    3. If that doesn't work, try reinstalling Carveco.
    4. If the problem persists, contact Carveco support for further assistance.

    Hope this helps!

    0
    Comment actions Permalink

Please sign in to leave a comment.

Didn't find what you were looking for?

New post